Clipper Cutting: Please Don’t Cut By Numbers – Part 4

Barbering or Men’s haircutting is a great business to be in and can be fun and rewarding. Being a barber can also give you a good steady income with job security. The barber business is a respected profession which should be taken seriously. We are all fortunate to be making our living this way in relaxed and relatively stress free atmosphere.

In previous blogs I wrote about why it is not a good idea to cut by numbers. In this blog I am going to give you real life examples on how to explain to the customer how they get their haircut. This will also be how they ask for their haircut next time they come into the barbershop or salon.

When talking with the customer of how high they like there fade there a couple of ways to go about it. You can ask them to point out where they like their fade; Low (just above the ear and below the occipital bone), medium (halfway to the temple area and the middle of the occipital bone), or high (to the temple area and above the occipital bone).

I personally like to measure the fade by the width of my fingers. Here are a few examples on how to explain or have your customer ask for their fade:

– 3 finger 3/8” taper
– 3 finger 3/8” taper with a 1finger 1/16” taper around the outline
– ½” Taper to the temples
– 2 finger ¼” Taper

These are just a few and you can come up with any combination. I will usually write this down on the back of a business card for the customer to carry with them so they know how to ask for their haircut. It makes the haircut sound much more detailed and is another reason for your customer to keep coming back to you.

Please visit for the very best in online clipper cutting education.

, , , , , , , , , ,

Comments are closed.